37 Degree Flare Fittings

A 37-flare fitting is an excellent pressure fitting having a broad selection of styles & shapes and is very extensively used all over the globe. Main features that call for its use are its simplicity, compactness in design, ease of assembly, high reliability, easy availability & global acceptance. These flare fittings can also be used as hose adapters.

The basic design is simple, which uses a flared tube end to hold & seal the medium under pressure. Main construction consists of three pieces: the body, sleeve & nut. The end of the tube is flared to 74 degrees included angle and held in between the body nose and the sleeve with a nut on top of them, thus resulting in a very effective seal between the fittings and the flared tube.

Straight flare fitting are normally manufactured from cold drawn bar stocks and all angular fittings from forgings. This kind of forged construction results in very close grain structure and also gives high reliability to the fitting eliminating all possibilities of leakage and can withstand high pressures with numerous makes and remakes even under severe operating conditions.

Also these fittings can be easily used in both metric and inch tubing's. One single 37 degree fitting body can take both metric and inch tubes just by change in sleeves. The nuts used are the same, so the cost of the component comes down drastically and also the inventory.

:: Click For Online Query ::

37 Degree Flare Fittings - Range

ANGULAR FITTINGS- CROSS

ANGULAR FITTINGS- ELBOW
45 DEG MALE ELBOW
B'HEAD 45 DEG ELBOW
B'HEAD ELBOW
ELBOW
FEMALE ELBOW
MALE ELBOW

:: Click For Online Query ::

ANGULAR FITTINGS- TEE
FEMALE TEE
MALE TEE
TEE

SPARES & ACCESSORIES
CAP
NUT & SLEEVES
PLUG

STRAIGHT FITTINGS
B'HEAD UNION
FEMALE CONNECTOR
FMALE CONNECTOR
REDUCING UNION
UNION

:: Click For Online Query ::